![]() ![]() The USB to Serial device will likely be detected at a different address, so try using tab completion (hit the key) after entering /dev/cu.PL2303 Note: If /dev/ttyUSB0 does not work, run dmesg to check where the USB adapter was detected. Linux: At the command line run sudo screen /dev/ttyUSB0 115200.Connect to the Raspberry Pi over the serial port.Plug USB connector into your computer's USB port.P01-2 is the pin adjacent to the outside of the board.P01-1 is the pin closest to the Micro-USB Power connector.Connect the USB Serial Cable to the Raspberry Pi Port1 as follows.Connect the Ethernet cable from the Raspberry Pi to the network switch.The label of the card should be facing out, so you can read the words (away from the Raspberry Pi). Please install the following driver (and software) as appropriate for your operating system: This might take as long as 20-25 minutes to finish. Wait for your SD card to be found and then click "OK" when prompted.Insert your SD card and click "Continue". ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |